My title


Mercedes-Benz V6 M272 intake Manifold Lever with Gasket Kit

Mercedes-Benz V6 M272 intake Manifold Lever with Gasket Kit

Part Number: AGA-6061-MB-TL-272K
Price: $206.00
  • This kit includes everything you need to replace the factory throttle lever on the Mercedes-Benz V6 M272 Engine.
  • The AGA throttle lever is made with 6061 aircraft grade billet aluminum throttle lever.
  • It has been engineered to reduce unnecessary tension on the throttle flaps while maintaining full range of motion.
  • This kit includes left and right intake manifold gaskets for the V6 M272 engine and our Throttle lever.

Ordering from Europe? Click here to buy from our European distributor KOED

Need help? See frequently asked questions about the Mercedes-Benz V6 M272 intake Manifold Lever with Gasket Kit

Downloadable PDFs

Models This Product Fits

  • V6 M272
  • V8 M273

Parts Included

Quantity 1
Part # AGA-6061-MB-TL
Description Mercedes Benz Throttle Lever
Quantity 1
Part # 272-141-23-80
Description Left Intake Mainfold Gasket
Quantity 1
Part # 272-141-22-80
Description Right Intake Mainfold Gasket
Total $206.00

Write Your Own Review

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars

These instructions are for experienced technicians only. This job should only be done by an experienced technician.


Remove Intake Manifold. Refer to Mercedes Benz Procedures.


Carefully disconnect the left & right side metal lever. Remove broken ball from plastic actuator rod. Remove center bolt (torque #30).

STEP 3: Installing New AGA Throttle Lever:

Install left & right side metal lever. Do not use excessive force. If the ball does not snap in easy, center spring clip then apply pressure and ball will click in. Install center bolt (torque to 80in lbs./ 9nm) with Loctite on threads only. NOTE: Do not over tighten. This can crush shoulder on bolt and cause bending at lever.


Check that lever moves freely and that lever does not interfere with stud. *If stud does interfere with lever, trim stud slightly until it clears. DO NOT REMOVE the stud all the way since it retains the wires.* Install actuator plastic rod on ball. Replace intake manifold gaskets. Install manifold according to Mercedes Benz procedure and torque valves. Clear codes in system.

What is the average repair time?

Using our parts, the Mercedes-Benz Manifold Lever installation repair takes approximately 4-5 Hours to complete.